Extrusion Punch Press

Glas-tek Software Solutions Inc. is pleased to announce the development of a punch press program for the glass and aluminum industry. This punch press has dies specially design by Glas-tek to eliminate the tedious job of manually drilling holes. Why drill these holes, when they can be punched in a matter of seconds.

Punch Press Benefits

  • Punch Press dies for all major aluminum suppliers
  • Dies for shear block holes for mullions
  • Dies for weeping holes and end punching for pressure plate
  • Dies for drain holes for curtain wall cap
  • Accurate every time
  • Cheap to operate
  • Multifunction capabilities
  • Air over hydraulic for quiet and safer operation
  • Reduced labour costs
  • Can be used as a bench top model or on a cart for portability
  • Eliminates scrap due to over drilling or errors made while countersinking
  • Multiple ports available

The punch press as shown above has two dies for Alumicor 2200 and 2500 series stock lengths. Pictured below is the final product after it has been punched by the press. They are now ready for assembly.

Shear Block Demo Video

Drain Hole Video Demo

Pressure Plate Video Demo

Please contact Glas-tek Software Solutions today at sales@glas-tek.com for an estimated cost for the punch press and shipping to your area!